Analog to DMX with 24 Channels, eDIN

Pathway eDIN Analog-to-DMX converts analog voltages or dry contact input to DMX512.

The eDIN #1006 converts 24 analog 0-10 VDC sources or 24 dry contact closures into a DMX512 signal. A built-in DMX merger combines signal output with other in-line #1006 interfaces, lighting consoles or controllers. Also may be used as a simple snapshot playback device, holding up to 24 ‘looks’.

FEATURES
• DMX512 start address and operating mode may be set from front panel interface or remotely using E1.20 RDM
• Indicator LEDs for power, processor, DMX input status and contact closure operation
• Convert 0-10 VDC input to DMX512 output levels
• Alternate contact closure mode, for off/full DMX control
• Recall mode allows capture and playback of up to 24 discrete, full universe ‘looks’
• LED indicator for CCI mode
• Built-in merger allows in-line operation with other DMX sources in either recall or input modes
• One DMX512-A/RDM data input connection
• One passive DMX512-A data through connection
• Data and power easily daisy-chained between modules
• Termination switch
• Independent test function, in both analog and contact closure modes
• Firmware field-upgradable using RDM (requires Pathway Pathport gateway and RDM utility program)