DMX/RDM eDIN Fully-Isolated Hub (8 Ports) (8")

MODES
• Mode 1 : RDM Hub
• Module detects and latches to a DMX input applied to any port. Automatically routes DMX signal to remaining ports as outputs. If a second source is applied, that source is ignored until the initial source stops.
• Mode 2 : RDM A/B Select
• Allows user selection, through use of dry contact closure, of input signal arriving at Port B to be selected and routed to the remaining ports, over signal arriving as input at Port A. When dry contact is open, the signal arriving at Port A will be routed.
• Mode 3 : Priority
• Provides predictable signal priority arrangements of DMX sources. Port A is given highest priority, Port H lowest. Module automatically senses DMX input on any port, and will route signal arriving at the highest priority port to the remaining ports as outputs. Module will automatically switch to any new signal arriving at a higher priority port, or fall back to the next lower priority signal when a signal stops.
• Mode 4 : Merge
• Provides HTP (highest-takes-precedence) merging of two DMX sources, regardless of which ports are used as inputs.

SPECIFICATIONS
• 250V fault protection on input and output ports
• Input operating voltage: 24-48 VDC
• 7W power consumption
• Operating conditions: -10 to +48°C; 10-90% relative humidity, non-condensing

STANDARDS COMPLIANCE
• ANSI E1.11 DMX512-A(2008)/USITT DMX512(1990)
• ANSI E1.20 RDM(2010) - Remote Device Management
• RoHS 2011/65/EU
• Class 2 Low Voltage

WEIGHTS AND DIMENSIONS
• 0.70 lb. (0.32 kg)
• 8.0” W x 4"H x 1.8” D (203 mm x 103 mm x 46 mm)