CDi DriveCore Power Amplifier with Analog Input, BLU Link Input - 4 Channels (600W)
$3,767.00
In stock
SKU
SP100650
The 600W Crown Audio CDi 4|600 4-Channel DriveCore Series Power Amplifier with BLU Link utilizes technology derived from the flagship Crown DriveCore Install series amplifiers, providing an impressive mix of high-performance, rich feature set, and competitive cost. The CDi DriveCore 4|600 offers streamlined functionality for most medium-sized installation such as cinema, houses of worship, bars, lounges, and more.
The DriveCore integrated circuit eliminates hundreds of components within the amplifier, reducing the variability of component values and increasing reliability, resulting in remarkable audio fidelity from an efficient design. The 4-channel amplifier is simple to use and includes a network control & monitoring, an advanced DSP circuit, and an easy-to-use, front-panel interface. The amplifier is equipped with two BLU Link RJ45 connectors, which can receive and send 256 fault-tolerant audio channels.
The amplifier is capable of driving up to 100 Vrms speaker loads without requiring a transformer and comes pre-loaded with JBL speaker tunings to help make installations quicker and easier. The CDi 4|600 features an Ethernet port for using HARMAN's HiQNet Audio Architect software for configuration and operation over a standard TCP/IQ network. The rear panel includes terminal block inputs and barrier strip outputs.
FEATURES:
• DriveCore Technology: patented DriveCore integrated circuit combines hundreds of discrete circuits into one chip for better performance, lower power consumption, and improved reliability
• BLU link digital audio transport—up to 256 channels of digital audio over CAT 5e cabling
• Supports configuration and control using HiQNet Audio Architect
• Monitoring and control over TCP/IP
• Color LCD and front-panel user interface for amplifier configuration, control, and monitoring
• Programmable GPIO (general purpose input/output) control port
• Digital signal processing (input/output EQ filters, crossover, input/output delay, LevelMAX limiters)
• Support for importing of FIR filter coefficients
• 20 device presets—1 factory and 19 user
• 96 kHz/32-bit floating-point signal processing
• Universal power supply with PFC for reduced current draw and industry-leading efficiency
• Power saving modes
• Remote power off—Sleep mode activated via AUX port
• 70/100 Vrms direct drive
• Each channel independently configurable for low z or high z operation
• Advanced protection circuits—amplifier and loads are protected against shorted outputs, DC, mismatched loads, overheating, over/under-voltage, and high-frequency overload
• Three-year, no-fault transferable warranty—your investment is fully protected
• Complies with GreenEdge by HARMAN—environmentally friendly practices in design, manufacturing, and packaging complement energy-efficient operation
• Support for BSS Audio Soundweb Contrio Ethernet wall controllers
• Included speaker tuning for various JBL speaker models
The DriveCore integrated circuit eliminates hundreds of components within the amplifier, reducing the variability of component values and increasing reliability, resulting in remarkable audio fidelity from an efficient design. The 4-channel amplifier is simple to use and includes a network control & monitoring, an advanced DSP circuit, and an easy-to-use, front-panel interface. The amplifier is equipped with two BLU Link RJ45 connectors, which can receive and send 256 fault-tolerant audio channels.
The amplifier is capable of driving up to 100 Vrms speaker loads without requiring a transformer and comes pre-loaded with JBL speaker tunings to help make installations quicker and easier. The CDi 4|600 features an Ethernet port for using HARMAN's HiQNet Audio Architect software for configuration and operation over a standard TCP/IQ network. The rear panel includes terminal block inputs and barrier strip outputs.
FEATURES:
• DriveCore Technology: patented DriveCore integrated circuit combines hundreds of discrete circuits into one chip for better performance, lower power consumption, and improved reliability
• BLU link digital audio transport—up to 256 channels of digital audio over CAT 5e cabling
• Supports configuration and control using HiQNet Audio Architect
• Monitoring and control over TCP/IP
• Color LCD and front-panel user interface for amplifier configuration, control, and monitoring
• Programmable GPIO (general purpose input/output) control port
• Digital signal processing (input/output EQ filters, crossover, input/output delay, LevelMAX limiters)
• Support for importing of FIR filter coefficients
• 20 device presets—1 factory and 19 user
• 96 kHz/32-bit floating-point signal processing
• Universal power supply with PFC for reduced current draw and industry-leading efficiency
• Power saving modes
• Remote power off—Sleep mode activated via AUX port
• 70/100 Vrms direct drive
• Each channel independently configurable for low z or high z operation
• Advanced protection circuits—amplifier and loads are protected against shorted outputs, DC, mismatched loads, overheating, over/under-voltage, and high-frequency overload
• Three-year, no-fault transferable warranty—your investment is fully protected
• Complies with GreenEdge by HARMAN—environmentally friendly practices in design, manufacturing, and packaging complement energy-efficient operation
• Support for BSS Audio Soundweb Contrio Ethernet wall controllers
• Included speaker tuning for various JBL speaker models
SPECIFICATIONS:
Power Amplifier
Number of Channels 4
Power Rating 600 W per Channel
1200 W Bridged
Load Impedance / Voltage Stereo:
2 / 4 / 8 / 16 Ohms per Channel
70 / 100 V per Channel
Bridged:
4 / 8 / 16 Ohms
140 / 200 V
Performance:
Protections DC Fault, Low Impedance, Open Circuit, Overcurrent, Overvoltage, Ultrasonic, Under-voltage
Frequency Response 20 Hz to 20 kHz ±0.25 dB (8 Ohms)
Damping Factor >1000
Input Sensitivity Line:
0.7 Vrms to 2.5 Vrms / -.8 dBu to 10.2 dBu (at 8 Ohms)
1 Vrms to 3.5 Vrms / 2.2 dBu to 13.2 dBu (at 70 V)
1.4 Vrms to 5 Vrms / 5.2 dBu to 16.2 dBu (at 100 V)
Input Impedance 10 Kilohms (Balanced)
5 Kilohms (Unbalanced)
Max Gain 34 dB (at 4 Ohms, at 8 Ohms, at 70 V, at 100 V)
Max Input Level +20 dBu
SNR >104 dB
THD 0.35% (at Rated Power)
Intermodulation Distortion =0.35%
Crosstalk >80 dB (Below Rated Power)
CMRR >70 dB
Signal Processing:
DSP 32-Bit Floating Point DSP at 96 kHz
Audio Delay Adjustable Up to 1000 ms per Channel
Crossover High-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Bessel
High-Pass:
16 to 20 kHz, 6/12/24/48 dB/Octave Butterworth
High-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Linkwitz-Riley
Low-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Bessel
Low-Pass:
16 to 20 kHz, 6/12/24/48 dB/Octave Butterworth
Low-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Linkwitz-Riley
EQ 8-Band Parametric EQ per Channel
Limiting Yes
Connectivity:
I/O 2 x Terminal Block 6-Pin Balanced Line Input
2 x Barrier Strip 4-Pin Speaker Output
Digital I/O 1 x RJ45 Ethernet Input/Output (Control)
2 x RJ45 BLU-Link Input/Output (I/O)
USB None
Power:
AC Input Power Universal:
100 to 240 VAC, 50 / 60 Hz
AC Power Connector 1 x IEC 15 A / NEMA 5-15
Current Consumption 120 VAC:
4.1 to 4.5 A (1/8 Power)
5 to 9.8 A (1/3 Power)
230 VAC:
2 to 2.3 A (1/8 Power)
2.7 to 5.1 A (1/3 Power)
Power Consumption 120 VAC:
201 to 225 W (1/8 Power)
178 to 434 W (1/3 Power)
230 VAC:
144 to 213 W (1/8 Power)
169 to 443 W (1/3 Power)
Physical
Display & Indicators Front Panel:
1 x Multicolor Graphic LCD
Rackmount Size 2 RU
Cooling Fan (Variable Speed)
Thermal Dissipation 1512 BTU/hr (Maximum)
Dimensions 19.0 x 3.5 x 12.2" / 48.3 x 8.9 x 31.1 cm
Weight 16.3 lb. / 7.4 kg
Packaging Info
Package Weight 21.1 lb.
Box Dimensions (LxWxH) 21.8 x 18.7 x 7.9"
Power Amplifier
Number of Channels 4
Power Rating 600 W per Channel
1200 W Bridged
Load Impedance / Voltage Stereo:
2 / 4 / 8 / 16 Ohms per Channel
70 / 100 V per Channel
Bridged:
4 / 8 / 16 Ohms
140 / 200 V
Performance:
Protections DC Fault, Low Impedance, Open Circuit, Overcurrent, Overvoltage, Ultrasonic, Under-voltage
Frequency Response 20 Hz to 20 kHz ±0.25 dB (8 Ohms)
Damping Factor >1000
Input Sensitivity Line:
0.7 Vrms to 2.5 Vrms / -.8 dBu to 10.2 dBu (at 8 Ohms)
1 Vrms to 3.5 Vrms / 2.2 dBu to 13.2 dBu (at 70 V)
1.4 Vrms to 5 Vrms / 5.2 dBu to 16.2 dBu (at 100 V)
Input Impedance 10 Kilohms (Balanced)
5 Kilohms (Unbalanced)
Max Gain 34 dB (at 4 Ohms, at 8 Ohms, at 70 V, at 100 V)
Max Input Level +20 dBu
SNR >104 dB
THD 0.35% (at Rated Power)
Intermodulation Distortion =0.35%
Crosstalk >80 dB (Below Rated Power)
CMRR >70 dB
Signal Processing:
DSP 32-Bit Floating Point DSP at 96 kHz
Audio Delay Adjustable Up to 1000 ms per Channel
Crossover High-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Bessel
High-Pass:
16 to 20 kHz, 6/12/24/48 dB/Octave Butterworth
High-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Linkwitz-Riley
Low-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Bessel
Low-Pass:
16 to 20 kHz, 6/12/24/48 dB/Octave Butterworth
Low-Pass:
16 to 20 kHz, 12/24/48 dB/Octave Linkwitz-Riley
EQ 8-Band Parametric EQ per Channel
Limiting Yes
Connectivity:
I/O 2 x Terminal Block 6-Pin Balanced Line Input
2 x Barrier Strip 4-Pin Speaker Output
Digital I/O 1 x RJ45 Ethernet Input/Output (Control)
2 x RJ45 BLU-Link Input/Output (I/O)
USB None
Power:
AC Input Power Universal:
100 to 240 VAC, 50 / 60 Hz
AC Power Connector 1 x IEC 15 A / NEMA 5-15
Current Consumption 120 VAC:
4.1 to 4.5 A (1/8 Power)
5 to 9.8 A (1/3 Power)
230 VAC:
2 to 2.3 A (1/8 Power)
2.7 to 5.1 A (1/3 Power)
Power Consumption 120 VAC:
201 to 225 W (1/8 Power)
178 to 434 W (1/3 Power)
230 VAC:
144 to 213 W (1/8 Power)
169 to 443 W (1/3 Power)
Physical
Display & Indicators Front Panel:
1 x Multicolor Graphic LCD
Rackmount Size 2 RU
Cooling Fan (Variable Speed)
Thermal Dissipation 1512 BTU/hr (Maximum)
Dimensions 19.0 x 3.5 x 12.2" / 48.3 x 8.9 x 31.1 cm
Weight 16.3 lb. / 7.4 kg
Packaging Info
Package Weight 21.1 lb.
Box Dimensions (LxWxH) 21.8 x 18.7 x 7.9"
| Weight | 22.000000 |
|---|---|
| Length | 22 |
| Width | 18 |
| Height | 8 |
| Color | Black |
| Compatibility | BLU Link |
| Manufacturer | Crown by HARMAN |
| Manufacturer Model Number | CDi4x600BL |
| Manufacturer Part Number | NCDI4X600BL-U-US |
| UPC | $691,991,006,975 |
| Size | 4 Channels |
Write Your Own Review